00311377

Tech 21 (Used)

S$550.00
Product Code: Bronzewood 60
Availability: 1
Views: 1019
Units Sold: 0

(Used)

Dual Channel, 60 Watt Acoustic Combo
The Bronzewood 60 was specifically designed to get the very best from your electro-acoustic instruments, while integrating a dedicated microphone channel. The Guitar channel features an adjustable compressor, reverb, active three-band EQ with semi-parametric sweepable mids and SansAmp tube/mic emulation circuitry to remove the harsh harmonics from piezo pickups. The Mic channel has switchable phantom power for condenser microphones, active EQ and mixable reverb. From the Elvis-cool crocodile vinyl covering to the sweet open tone, this is the last word in amps for any acoustic player headed for the stage or studio.

 

 

Guitar Channel
 
Mic Channel
Compressor, ranging from 1:1 to 5:1 XLR mic level female input
Phase switch 24V phantom switch to power a condenser microphone (or any other phantom powerable product, perhaps a SansAmp Acoustic DI?)
Preamp control 3-band active EQ controls
Notch filter Reverb Mix to control the balance of reverb between the Guitar and Mic channels
Mid Shift and Mid are sweepable, semi-parametric EQ controls and range from 170Hz to 3kHz, ±16dB, respectively  
Active tone controls, boost or cut ±12dB

Unique Blend control enables you to determine the ratio of direct instrument signal and SansAmp Tube/Microphone Emulation circuitry

Full-length, 6-spring Accutronics® reverb
bronzwood
Click to enlarge
 
BW60 ADDITIONAL FEATURES
Special design 12” speaker and high frequency horn.
Mid Shift and Mid EQ controls range from 170Hz to 3kHz, ±16dB respectively.
SansAmp XLR Direct Out for stage and studio applications allows you to go direct to any mixing console. For live gigs, you can run directly into the P.A. system. In larger venues, you’ll be able to utilize the P.A. monitors to supplement your stage volume.
Full length, 6-spring reverb.
A Reverb Mix controls the balance of reverb between the Guitar and Mic channels.
Headphone output, which can also be used as a 1/4” direct out.
Effect Loop.
Footswitch jack that accepts any alternating footswitch to control the Reverb function. An optional factory footswitch is available.
 
SPECIFICATIONS
Model Number: BW60
Input Impedance: (Guitar):  4.7M Ohms 
(Mic):  3.3k Ohms
Nominal Input Level: -20dBu
Optimal Output Load: 8 Ohms 
Power Output: 60W
Effect Loop Input Impedance 1MOhm
Maximum Effect Loop Input approx. -10dBm
Nominal Effect Loop Output Impedance 1KOhm
Nominal Effect Loop Output approx. -10dBu
Effect Loop Output Level* 0 to -10dBu
Maximum Power Consumption: 120W
AC Input Power: (Factory set): 100V, 117V, 220V, 230V, 240V
NOTE: AC power cannot be switched. See authorized dealer/distributor for voltage modification information. 
Cycles:

50/60 Hz 

Speaker: Model #2112-A, Special design 12" / 100W - 8 Ohms
Horn: Model #2125-H, Special design / 60W - 8 Ohms
Dimensions: 20"w  x 17"h x 11"d
Weight:

38 lbs

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:





Panel Tool

Reset